FS25 Hand Throttle V1.6.0.0
Add a real hand throttle to every tractor. When using a manual gearbox, adjust the throttle or RPM and shift through the gears. With a CVT, choose the speed in the same way as with the drive lever on modern tractors. The hand throttle can also limit the engine’s maximum RPM on any gearbox.
Features
- Manual gearbox: adjust the throttle or RPM while working through the gears.
- CVT: choose the speed like you would with the drive lever of modern tractors.
- Any gearbox: limit the engine’s maximum RPM.
Changelog
V1.6.0.0
- For CVT vehicles that have CVT Addon installed, % mode is now available. It uses the increase/decrease buttons to control the CVT Addon hand throttle. An analog throttle lever (HOTAS) is no longer needed, for example, to increase engine RPM for faster hydraulics on wheel loaders and excavators.
- On these vehicles, the modes cycle as follows: system off -> % -> km/h -> RPM limit -> system off.
- Pausing, turning off the system, stopping the engine or leaving the vehicle resets the CVT Addon hand throttle to 0.
- If the hand throttle is off, the mod does not change the value of an analog lever assigned to the CVT Addon axis.
- Without CVT Addon, there are no changes. In the base game, hydraulics do not rely on engine RPM.
V1.5.0.0
- The hand throttle and cruise control cannot operate at the same time, just like a car’s cruise control and speed limiter.
- When the system is off and there is no HUD, the game’s / Vehicle Inspector’s cruise control works normally. When a mode is active or the system is paused, cruise control is blocked, allowing the same buttons to be bound to both.
- Increase/decrease is now a single action that supports keys, buttons and analog axes.
- Action names were changed from HT_* to ETHT_*, so key bindings must be set again.
