FS25 Advanced Damage System BETA 11

FS15 Mods | FS17 Mods | FS19 Mods | FS22 Mods | FS25 Mods |
FS 25 Other

FS25 Advanced Damage System BETA 11

In Farming Simulator 25, Advanced Damage System changes the way vehicle wear, failures and servicing work. Every machine contains its own components and consumables, while use, workload and maintenance influence reliability. ADS remains in open beta, meaning that bugs and compatibility problems are possible. Create backups of your savegames before updating, and test new features in a separate save.

YOU NEED: Vehicle Years

Features

  • Pumps, hoses, cylinders, batteries and other vehicle components wear out and fail in different ways. Cold starts, demanding loads, overheating and missed maintenance may reduce their service life.
  • When a hydraulic cylinder is worn, a raised load can slowly move down. A battery in poor condition may also make starting the engine more difficult.
  • The response speed of steering, hitches, booms and implements depends on hydraulic flow, pressure and oil temperature. Operation may become slower with cold oil, low fluid levels or blocked filters.
  • Hydraulic components that are worn can lose pressure, while damaged hoses may leak or burst. Vehicles equipped with separate hydraulic circuits have their own oil and filter.
  • Before beginning a shift, walk around the vehicle to inspect fluids, filters, the battery and lubrication points, and to find visible fault signs. Manual and automatic pre-shift inspections use the same results.
  • Inspect separate vehicle zones with the impact wrench and save the results in the maintenance log. With the wrench in your hand, choose Repair to select the component that should be repaired or replaced.
  • Fluids can be added at dedicated filler points, while filters and batteries are replaced at the vehicle. Individual lubrication points must be greased separately.
  • Collect used oil and coolant in the 65 L Fluid Drain Cart, then pump the waste into reusable 200 L drums for disposal by a dealer. Gameplay settings also provide menu-based draining.
  • The Field Service 620 case or a vehicle toolbox can hold tools and supplies for transport.
  • Battery work can be done with a portable battery tester, jumper cables or the Mobile Jump Starter.
  • Radiators and air intakes can be cleaned using a mobile compressor or a blow gun connected to onboard air. Vehicles lacking onboard air can receive a Service air kit.
  • Arrange a dealer visit, request a mobile mechanic or operate your own workshop with staff and equipment. Dealer service queues are used for visits and warranty work, while mobile service charges a call-out fee.
  • Farm managers in multiplayer can permit another farm to service their vehicles by hand. Workshops owned by players may also accept paid jobs from farms that visit them.
  • Compatible vehicles can receive engine tuning, and available upgrades also include transmission adjustments and protective coatings.
  • Warranty coverage may be lost when maintenance is neglected. Leased equipment returned with faults or overdue service may result in additional charges.
  • Inspections, workshop services, spare parts and tool storage are available through the vehicle radial menu.
  • Markers on the vehicle indicate the locations where an inspection or tool can be used.
  • Hydraulic readings and fault warnings appear on the dashboard. Indicators for turn signals, headlights, work lights and beacons are optional.
  • Join Discord to participate in the beta, talk about features and report bugs. Provide a short issue description, reproduction steps and your log.txt.

Join the ADS Discord:

Changelog

BETA 11

  • 0.12.1.3: The new DP-18 portable drain pan was added. It collects up to 18 L of used oil or coolant and allows direct pouring into a waste drum.
  • 0.12.1.3: Two 40 L waste tanks are now fitted to the mobile field service station. Either hose can draw waste fluids from a drain pan or cart, after which the station can pump them into a waste drum.
  • 0.12.1.3: Scanning every zone with the impact wrench now provides the same performance readings as a dealer inspection performed at the same depth.
  • 0.12.1.2: Deep service points and high diesel fillers can now be reached more easily from beside the vehicle.
  • 0.12.1.2: The combine now supplies grain header reels with hydraulic flow according to the width of the header.
  • 0.12.1.2: The maintenance log of a vehicle can be opened directly through the ADS menu. Admins and farm managers may also exclude vehicles from the list or enable them again.
  • 0.12.1.2: Tie-down straps now conform more closely to the shape of portable service equipment.
  • 0.12.1.1: Low oil lowers hydraulic power. If the pump runs dry, hydraulic flow stops and the pump may be destroyed within minutes.
  • 0.12.1.1: Loader lifting and steering were improved, and fixed self-propelled machines that struggled with lifting their own headers were corrected.
  • 0.12.1.1: When The CMM Farmer’s Red Diesel mod is active, the mobile field service station now supports red diesel.
  • 0.12.1.1: Fluid stains now settle onto the floor beneath ramps and lifts that are moving.

BETA 10

  • 0.12.0.0: Using the impact wrench, individual components can now be repaired or replaced by selecting the applicable vehicle zone.
  • 0.11.3.5: Zone inspections with the impact wrench were added, and manual and automatic pre-shift inspections were connected.
  • 0.11.3.5: A blow gun using onboard compressed air was added, together with a Service air kit for vehicles that do not have onboard air.
  • 0.11.3.5: The Service partners menu was added for granting or revoking service access between farms.
  • 0.11.3.4: Dedicated filler points for fluid checks and top-ups were added.
  • 0.11.3.4: The Field Service 620 case now provides eight shared slots, and jumper cables can be stored as a tool.
  • 0.11.3.3: Individual grease points and progress for reloading the grease gun were added.
  • 0.11.3.3: Compressor cleaning now works directly on the radiator and air intakes.
  • 0.11.3.2: Walkaround pre-shift inspections and dedicated points for replacing batteries and air filters were added.
  • 0.11.3.2: Vehicle toolboxes and physical service tools were added, along with optional dashboard light indicators.
  • 0.11.3.1: Service markers can now be seen with empty hands, and drain and filter placement was improved for different vehicle types.
  • 0.11.3.1: Several outlets can now be drained simultaneously, and the coolant temperature requirement for draining was removed.
  • 0.11.3.0: Manual fluid draining and filter replacement were added, as well as a 65 L drain cart and reusable 200 L waste drums.
  • 0.11.3.0: A mobile compressor and jacks were added, together with support for testing and charging batteries after removal.
  • 0.11.3.0: Cross-farm servicing and paid workshop orders from guests were added.
  • 0.11.0.3: Hydraulics were redesigned around oil flow, pressure and temperature, influencing steering, lifting and implement operation.
  • 0.11.0.3: Separate HVLP 46 circuits and progressive hydraulic failures were added, including leaking and ruptured hoses.
  • 0.11.0.3: Exhaust smoke and dashboard warnings were reworked.
  • 0.10.0.8: Repair contracts through The Contractor and pre-purchase inspections for vehicles from Used Equipment Yard were added.
  • 0.10.0.8: Workshop and inspection tooltips were improved.
  • 0.10.0.7: Player-owned mobile workshops, The Contractor staff integration and configurable AI maintenance were added.
  • 0.10.0.7: Warranty assessments and the requirements for returning leased vehicles were reworked.
  • 0.10.0.6: Repeat mobile workshop orders on dedicated servers and incorrect transmission overheating caused by passive implement movement were fixed.
  • 0.10.0.6: Item sale and disposal were moved to G.
  • 0.10.0.5: The sale and disposal of used fluids and removed parts, including batteries and filters, were unified.
  • 0.10.0.5: Workshop labour charges were separated from parts and materials, and service duration scaling was corrected.
  • 0.10.0.4: Simplified workshop management, diagnostic smoke and fault sounds, plus a reversing fan upgrade were added.
  • 0.10.0.4: Waste-fluid collection and dealer disposal were added, along with resale for removed parts.
  • 0.10.0.3: Removable air filters and cleaning with compressed air were added.
  • 0.10.0.3: The physics of portable equipment was improved

Author: id577
This content was uploaded by website visitors. If you notice any mistake, please let us know.


Finding a game interesting after investing 300 hours into it can become a bit challenging. But with mods as long as there is a new update is assured, you are guaranteed a few more hours of new exciting gameplay. FS 25 Other Mods are one of the greatest upgrades and can make your game unique. Downloading and adding FS25 Advanced Damage System BETA 11 Mod to your game is not difficult at all - you simply need to save a file and run it.



You may also like...

Leave a Reply

Your email address will not be published. Required fields are marked *