FS25 Water Pump Pack V1.4.2.1
With this pack, Farming Simulator 25 receives 7 rotary lobe pumps, connectable hoses and a complete system for transferring fluids. Water can be collected from lakes, rivers, tanks or MapFlood floodwater, then transferred and pumped into vehicles, containers or other bodies of water.
Features
- Rear three-point hitch
- Front three-point hitch
- Forklift skid
- Crane lifting frame
- Roll-off container pump station
- Depending on the model, the drive is powered by the PTO or a diesel engine.
- Each hose can be picked up separately, carried, laid out, extended and connected to another hose.
- The hoses use their own physics and feature smooth bends with sturdy couplings.
- Several pumps may be connected in series by linking the pressure outlet of one pump to the suction side of the next.
- With every pump active, the individual flow rates are combined. This allows longer transfer lines to be assembled as well.
- Interactive Control
- Attach Implements Manually
- Realistic Exhaust Smoke
- Original GIANTS diesel sounds
- Freely selectable pump and hose colors
- Dedicated shop category: Water Pumps & Hoses
Controls
- Left Alt + 1/2: Start/stop engine
- Left Alt + 3/4: Turn pump on/off
- Left Alt + 5/6: Change RPM
- Left Alt + 7: Refuel diesel
- Left Alt + N: EMERGENCY STOP
- Left Alt + 8: Connect/extend hose
- Left Alt + 9: Connect/disconnect coupling
- Left Alt + 0: Stow hose
- Left Alt + V: Stow all hoses
Specifications
- The roll-off container is equipped with a 400-litre diesel tank.
- PTO pumps run at speeds from 350 to 1,000 RPM.
- Maximum suction height: 8.5 m.
- Displays show RPM, flow rate, pressure, vacuum and fuel level information.
Hose System
Blue = suction side
Red = pressure side
Pumping Fluids
Supported sources:
- Lakes and rivers
- MapFlood floodwater
- Tanks and trailers
- Water, milk, slurry, digestate, liquid fertilizer, herbicide, diesel, AdBlue, oils and other liquids
On the pressure side, vehicles, tanks and unloading points can be filled. Liquid may also run directly from a free hose end.
When MapFlood floodwater is pumped out, it is correctly taken into account.
Changelog
- V1.4.2.1
New water jet: every frame now follows the actual ballistic trajectory, determined by exit velocity from the flow rate and hose cross-section, the direction of the hose end and gravity, until reaching the ground or water surface. It appears as one continuous stream without discontinuities in hose thickness and uses the game’s waterfall material. At the impact point, the game’s spray is scaled to the flow rate, while the distorted rice-field water surface has been removed. Fittings and signs on the completed model have been measured: pressure gauges are positioned on the uppermost surface below the dial, color rings surround the actual pipe circumference, and signs appear only on straight pipe sections, long, two-line or short according to the available space. Nothing is embedded in the model anymore. Interactive-Control buttons are shown 1 m farther away and stay visible.
